[. . . ] [. . . ] Support ATA 33/66/100/133 Bootable Hot swap - device can be removed and Added without system shut down or restart Simple plug and play, no drivers required Compatible with 98SE, Me, 2000, XP Package Contents SATA Converter board Y-cable for power SATA Data Cable Installation It is easy to install the SATA converter board to any IDE device because they are foolproof. The SATA cable can only go in one way to the SATA Converter board or SATA controller card. Make sure that power is connected to the Converter Board and the Device (hard disk, CDROM drive etc. ) Connect one end of the Serial ATA cable to the Converter board and the other end to the SATA controller. Connect the Converter board to the IDE device and Y-Splitter power cord. Note: Turn Off your computer before adding any new device to avoid short circuit. [. . . ] [. . . ]